Filling The Water Boiler - Wella HAIRSPA ION Mode D'emploi

4 Preparing appliance
Figure 3
58
1521126, Edition 2012-11, Version 4
4.3

Filling the water boiler

Electric shock hazard
• Always remove the water boiler 6 from the appliance
before filling and always fill it away from the appliance.
• Do not pour water into the compartment 3, into which the
water boiler 6 is inserted.
Damage to the appliance
• The water boiler 6 must be replaced in the case of cracks,
leaks or irremovable limescale.
Damage to water boiler
• Do not immerse the water boiler 6 in water or other
liquids.
• Do not put the water boiler 6 in the dishwasher.
1. Push the lock of the cover 5 forwards.
➥ The cover 5 automatically opens upwards.
2. Open / unlock the water boiler 6 with the handle 1 and lift it out of
the compartment 3.
Risk of scalding
• Only fill the water boiler 6 with water.
• Aromas and additives may not be used.
Aromas and additives may have an adverse effect on the
treatment result, possibly even damage health or escape
from the steam distributor 3 as hot liquid or foam.
3. Fill the water boiler 6 up to the max mark with water.
➥ The level indicator 2 shows the water level.
4. Place the water boiler 6 vertically in the compartment 3 using the
side guideways 4 and slide it down slowly and carefully.
Do not spill any water into the compartment 3.
•
5. Close the lid by pulling down the handle 1.
➥ This locks the water boiler 6 into place.
6. Press the cover 5 down until it audibly snaps into place.
1WARNING
NOTICE
1WARNING