Preparing Appliance; Important Information On Use Of The Water Boiler; Checking Seals On Water Boiler - Wella HAIRSPA ION Mode D'emploi

4

Preparing appliance

Figure 1
Figure 2
4.1

Important information on use of the water boiler

Risk of scalding
• The water boiler 6 is solely intended and approved for use
in the Hairspa Ion steam appliance.
The water boiler 6 is a wearing part. To prolong its service life and for
best possible appliance performance we recommend using lime-free/dis-
tilled water.
The use of tap water may limit its life. It holds enough water for approx. 1
hour of treatment time.
The water boiler 6 contains small ceramic pieces 7. These ceramic
pieces 7 considerably delay the development of limescale. They must
therefore not be removed from the water boiler 6.
Danger of suffocation
• The ceramic pieces 7 could be swallowed or inhaled by
children.
• Do not remove the ceramic pieces 7 from the water boiler
6.
• Keep the water boiler 6 away from children.
We recommend that the remaining water be emptied from the water boiler
6 at the end of each working day and the water boiler 6 then be rinsed
out with cold water.
4.2

Checking seals on water boiler

Risk of scalding – damage to the appliance
• If the seals 1/2 are not in place, hot steam will escape
from the appliance.
• Check seals 1/2 before integrating the water boiler 6
into the appliance.
1. Check seals 1/2 for cracks or damage.
If you detect any dirt or damage, clean the seals 1/2 as described in
•
"Section 6.7.1" page 74 and replace them, if necessary.
2. Check that seals 1/2 are securely in place:
the oval seal 2 must fit in the groove with the wide side facing out-
–
wards,
the round seal 1 must fit in the groove.
–
1WARNING
1WARNING
1WARNING
1521126, Edition 2012-11, Version 4
57