7
TECHNICAL DATA
7.1
Conformity
The T-CUT tubular/pipe module conforms to the EC Directives according to the EC Declaration of Conformity.
7.2
Standards
The applied standards, which verify conformity with the EC Directives, can be found on the EC-Type Examination
Certificate and / or the EC Declaration of Conformity.
7.3
Product Data
Please refer to the product-specific data sheet for the product data.
7.4
Operating and Usage Conditions
In order to monitor the flow rate and pressure for the membrane application, the system must be fitted with
control valves for cross-flow, pressure control etc.
When planning and constructing a membrane system, ensure that the module is not exposed to any external
mechanical loads. By using flexible supply lines, vibrations and thermal material expansion of the pipes and the
module can be absorbed without damaging the module (in particular the connections).
NOTE!
• The operating conditions (cross-flow and trans-membrane pressure) are dependent on the specific filtration
application and should be optimized by means of laboratory or pilot tests!
• The limit values for pressure and temperature must not be exceeded.
• The ambient temperature must not exceed the medium temperature and must not give rise to frost.
Please refer to the product-specific data sheet for further information on operating and usage conditions.
7.4.1
Compatible Media
Aqueous media (within certain pH and temperature ranges – please refer to product-specific data sheet for
precise information).
When using media not specified in the product-specific data sheets, please consult a representative of Bürkert
Fluid Control Systems beforehand. The use of unnamed media without such prior consultation is the responsibility
of the user.
12
english
Type T-CUT
TechnicalData