Installation In A Filtration System - Burkert T-CUT Manuel D'utilisation

Masquer les pouces Voir aussi pour T-CUT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8.3
Installation in a Filtration System
NOTE!
Risk of material breaking.
▶ Attach and connect the module in such a way that vibrations from the system cannot be transferred to the
module.
The module must be attached horizontally on the frame of the filtration system by a holder (e.g. 2 clamps).
It is not adequate to attach the module by the connections only.
Check the seals to ensure that they are clean. Only use clean seals.
Loosely connect the feed inlet (connector: IN) first, then the concentrate outlet (connector: OUT), and finally
the permeate outlets of the pipe.
Ensure that the seals are not displaced when establishing the connections.
Check that none of the connections is subject to mechanical stresses.
Check that the seals are seated correctly.
Alternately tighten the connections.
NOTE!
Damage to the connections.
▶ Do not use force to tighten the connections! Use of excessive force in tightening may cause fractures in the
connections.
14
english
Type T-CUT
Installation

Publicité

Table des Matières
loading

Table des Matières