Device description (figure A/B)
1.
Tank
2.
Tank lid
3.
Exhaust
4.
Frame
5.
Suction neck
6.
Rubber foot
7.
Oil level indicator
8.
Oil draining screw
9.
Oil low level sensor
10. ON/OFF switch
11. Bowden starter
12. Throttle lever
13. Filling neck
14. Output neck
15. Saturator
16. Air filter
17. Carburettor
18. Draining screw
19. Gasoline cock
Accessories (Fig. C)
1.
2 x hose connector
2.
3 x hose clamps
3.
1 x wrench for spark plugs
4.
1 x foot valve (strainer)
EU DECLARATION ON CONFORMITY
The company
Güde GmbH & Co. KG
Birkichstrasse 6
74549 Wolpertshausen
Germany,
hereby declares that the design and structure of the devices
listed below and in designs marketed conforms to
applicable basic requirements of the EU directives on safety
and hygiene.
This declaration on conformity becomes void in
case of a change to the device not consulted with
us.
Identification of the devices:
Engine pump GMP 100
Order No.:
#94253
Applicable EU directives:
2006/42 EC
2004/108 EC
2000/14 EC
2002/95 EC
1907/2006/EC
Harmonized standards used
EN 809:1989/AC:2002
EN 1679-1:1998
Certification authority:
TÜV SÜD Produkt Service GmbH,
Ridlerstr. 65, 80339 München, Germany
Reference No.:
No.Z1A 070563423002
Date/signature of manufacturer: 29.10.2010
Information about signer:
Arnold
Technical documentation:
managing director, Mr
J. Bürkle FBL; QS
Warranty
The warranty applies exclusively on material or production
defects. For warranty claims, please submit an original proof of
purchase with date of purchase indicated.
The warranty does not cover unprofessional use, such as
overloading, violent use, damage caused by third party or a
thing. The warranty also does not cover failure to comply with
the operation manual and normal wear and tear.
Technical information GMP 100
Engine type (air
cooled)
Volume of cylinders
Motor power
Max delivered
volume
Max water pressure
in piping
Max suction lift
Max total head
Ø pressure/suction
connector
Tank volume
Pressure connector
Fuel
Engine oil
Max water
temperature
Noise level
Weight
Dimensions length x
width x height
General safety instructions
Please read through this user guide and make sure you
know all controls and proper use of this product. We shall
not be responsible for damage caused by non-adherence
of the instructions and procedures in this user guide.
Damage due to non-adherence of the instructions and
procedures are excluded from warranty. Keep the user
guide well and pass it to a new owner of the machine.
Children and person not informed about content of this user
guide must not operate the machine. Supervise children to
prevent playing with the machine. Applicable directives in
certain countries restrict minimum age of the potential user and
these directives must be respected.
Physically and mentally handicapped persons or persons with
sensorial limitations must not operate the machine albeit under
supervision of a security engineer or based on instructions for
operation received from a responsible person.
Please obey the special safety instructions listed in the chapters
of this user guide.
Cautions and instructions with the following symbol must be
followed with special care:
Failure to comply with this instruction may result in
hazard to humans and/or material damage!
Check the machine for transport damage. In case of damage,
inform your sales representative immediately.
The pump is not suitable for pumping of salt water,
faecal solids, flammable, corrosive, explosive and other
11
4 Takt-Motor
97,7 ccm
1,1 kW – 1,5 PS
10.000 l/h
1,5 bar
4 m
15 m
ca. 40 mm
1,4 l
1,5'' AG
Benzin bleifrei
SAE 15W-30
bis + 40°C
LWA 103 dB
13 kg
360x310x380 mm