Preparation Of The Coating Material; Start-Up - WAGNER WallPerfect Flexio 990 Mode D'emploi

WallPerfect Flexio 990 WallPerfect Flexio 990
Pay attention to the quality of the adhesive tape used.Do not use excessively
i
strong adhesive tape on wallpaper and painted surfaces, in order to avoid
damaging these surfaces when removing the tape. Remove adhesive tape
slowly and evenly; do not use jerky movements. Do not leave adhesive tape
on surfaces any longer than necessary, in order to minimise the possibility
of residues when removing. Also observe the adhesive tape manufacturer's
instructions.

9. Preparation of the Coating Material

Mix the material well in the original container. When using interior wall paint, an agitator
is recommended.
Flexio 990 has been developed for use with all conventional paints in their
i
undiluted form. If the surface is smooth and the paint you are using is very thick
and gel-like, dilute it by 10%. Dilution can be necessary if the atomisation is
coarse or if the flow rate is too low even at the maximum setting.
Detailed information about the various materials and the maximum permitted
dilution can be found on the manufacturers' technical data sheets (e.g. available
on the Internet). Our online database Wagner Spray Guide has tips on using
many materials tested by our experts: www.sprayguide.wagner-group.com
Spray material that is at least at room temperature provides a better spray
i
result.

10. Start-up

•
Put the machine down only on a level, clean
surface.
•
Before connecting to the mains supply, be
sure that the supply voltage is identical with
the value given on the rating plate.
•
Take the suction hose (fig. 2, 1) out of the
holder.
•
Pull the yellow handle (fig. 2, 2) away from the
device and unhook it.
•
Remove the material hose (fig. 2, 3) and the
electric cable from the device.

1
3
GB D
2
37 37