Preparation Of The Workplace; Preparation Of The Coating Material - WAGNER WALL EXTRA I-SPRAY 1300 Mise En Service

Wall Extra I-Spray 1300
Before using the attachment, read these operating instructions and familiarise
yourself with the operating instructions for the basic unit. The safety instructions
for the basic unit apply to this Wall Extra I-Spray spray attachment.
The Wall Extra I-Spray spray attachment has been especially developed for the
application of interior wall paints. A high feed rate and working speed are the main
features of this spray attachment.
•
CAUTION! The units may only be used with a functional valve. If paints rises in the
ventilating hose (Fig. 1 A, item 14) do not operate the unit further!
Dismantle and clean the ventilating hose, valve and diaphragm and replace
the diaphragm if necessary.
•
Do not place the spray gun on the side.
•
Do not combine components from different spray attachments.
The parts could be damaged.
1) Spray jet adjustment ring
3) Air cap
5) Nozzle
7) O-Ring
9) Trigger
11) Suction tube
13) Feed hopper
15) Valve cover

Preparation of the workplace

Sockets and plugs must be masked. Risk of an electric shock as a
consequence of sprayed material entering the socket!
Mask all the areas and objects that are not to be spray painted, or
remove them from the work area. No liability is assumed for damage
due to overspray.
Silicate paint corrodes glass and ceramic surfaces upon contact! All
such surfaces must therefore be completely covered.

Preparation of the Coating Material

Spray material that is at least at room temperature (e.g. diluted with warm
i
water) provides a better spray result.
Attention! Do not heat spray material above 40°C.
Interior wall paints can be sprayed undiluted or slightly diluted with the spray attachment
provided. Detailed information is available in the technical data sheet of the manufacturer
( Internet download).
1. Stir the material thoroughly and dilute it in the container as per the recommended
dilution (an agitator is recommended for stirring).
Description (Fig. 1 / 1A)
2) Union nut
4) Air screen
6) Needle
8) Material quantity regulation
10) Container seal
12) Container
14) Ventilating hose
16) Diaphragm
GB
7