Preparation Of The Coating Material; Start-Up - WAGNER W 690 FLEXIO EXTRA KIT Mode D'emploi

GB
Pay attention to the quality of the adhesive tape used.
i
Do not use excessively strong adhesive tape on wallpaper and painted
surfaces, in order to avoid damaging these surfaces when removing the
tape. Remove adhesive tape slowly and evenly; do not use jerky movements.
Do not leave adhesive tape on surfaces any longer than necessary, in order
to minimise the possibility of residues when removing.
Also observe the adhesive tape manufacturer's instructions.

7. Preparation of the Coating Material

•
Mix the material well in the original container. When using interior wall paint, an
agitator is recommended.
W 690 has been developed for use with all conventional paints in their undiluted
i
form. If the surface is smooth and the paint you are using is very thick and
gel-like, dilute it by 10%. Dilution can be necessary if the atomisation is
coarse or if the flow rate is too low even at the maximum setting.
Detailed information about the various materials and the maximum permitted
dilution can be found on the manufacturers' technical data sheets (e.g. available
on the Internet).
Spray material that is at least at room temperature provides a better spray
i
result.

8. Start-up

Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
Put the machine down only on a level, clean surface. Otherwise, the gun may suck in
dust, etc.
1. Attach the carrying strap to the unit. (Fig. 2)
2. Mount the air hose (Fig. 3, A + B). Insert the air hose firmly into the connection of the
unit and the gun handle.
Wall Extra I-Spray spray attachment
3. Unscrew the container from the spray gun.
4. Aligning suction tube. (Fig. 4)
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When spraying horizontal surfaces, turn suction tube forward. (Fig. 4 A)
When spraying objects overhead, turn suction tube back. (Fig. 4 B)
5. Set the container on a sheet of paper, pour in the prepared coating material and screw
the container tightly onto the spray gun.
24
W 690 Flexio Extra Kit