WAGNER WallPerfect Flexio 990 Mode D'emploi page 49

WallPerfect Flexio 990 WallPerfect Flexio 990
With a second empty bucket you
i
can improve the cleaning result
as the dirty water is not pumped
through the system a second time.
•
Replace the paint container at the basic unit
with a bucket of water or an empty bucket.
•
Suspend the spray attachment with the
fixture (Fig. 25, 3) over the bucket.
•
Leave the pump on for about 10-15 minutes.
Renew the water as required.
After cleaning, pump all the
water out of the device and hose.
With pumps filled with water, at
temperatures below 0°C there is a
risk of frost damage.
•
Turn the machine off (position 0) and remove
the plug.
•
Push the stop upwards until you hear it click
into place.
•
Disconnect the material hose (fig. 26, 1) from
the spray attachment and remove the cover (2).
•
Pull out the red catch (fig. 27, 3) and remove
the pressure reducer (4).
•
Remove the valve (fig. 28, 5) and clean
thoroughly.
•
Clean the openings in the pressure reducer
(fig. 28, 4) using a brush and water.
3
4
3
2
1
5
GB D
4
47 47