Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
Before using the attachment, read these operating instructions and familiarise
yourself with the operating instructions for the basic unit. The safety instructions
for the basic unit apply to this WallPerfect spray attachment.
The WallPerfect spray attachment has been especially developed for the application of
interior wall paints. A high feed rate and working speed are the main features of this
spray attachment.
We recommend against using the WallPerfect spray attachment with
i
the W550.
1)
Gun body
3)
Nozzle seal
5)
Union nut
7)
Material quantity regulation
9)
Container seal
11)
Container
13)
Valve cover
15)
O-Ring
Preparation of the workplace
Cover all surfaces and objects that should not be sprayed, or remove
them from the work area.
Silicate paint corrodes glass and ceramic surfaces upon contact! All
such surfaces must therefore be completely covered.
Preparation of the Coating Material
Spray material that is at least at room temperature (e.g. diluted with warm
i
water) provides a better spray result.
Attention! Do not heat spray material above 40°C.
Interior wall paints can be sprayed undiluted or slightly diluted with the spray attachment
provided. Detailed information is available in the technical data sheet of the manufacturer
( Internet download).
1. Stir the material thoroughly and dilute it in the container as per the recommended
dilution (an agitator is recommended for stirring).
Sprayed material
Interior wall paint (dispersions and latex paint)
If the feed rate is too low even at maximum flow setting, dilute in steps of 5 -
2.
10 % until the feed rate meets your requirements.
6
Description (Fig. a)
Thinning recommendation
WallPerfect spray attachment
2)
Needle
4)
Nozzle
6)
Air cap
8)
Trigger guard
10)
Feed tube
12)
Ventilating hose
14)
Diaphragm
16)
Feed hopper
dilute by 10%
Publicité
Table des Matières
