Factory Setting; Programming - Becker Centronic UnitControl UC520 Notice De Montage Et D'utilisation

Coding switch setting
1. Lower position
2. Lower position
3. Lower position
Programming the daily run times
To program the desired UP run time, press the UP button for at least
6 seconds. The indicator lamp will then flash briefly three times. This drive
command will now be repeated every 24 hours.
To program the desired DOWN run time, press the DOWN button for at least
6 seconds. The indicator lamp will then flash briefly three times. This drive
command will now be repeated every 24 hours.
Overwriting the run times is possible at any time. Repeat the
programming phase to set the new desired daily run time.
Deleting the daily run times
To delete the UP and DOWN run times, press the reset button
All the run times, intermediate positions and tilt positions/
ventilation slots can be deleted by pressing the reset button
(with a ballpoint pen or similar object).
Intermediate position I
The intermediate position I is any shading solution position of
your choosing, situated between the upper and lower limit
positions. Both limit positions must be set before the inter-
mediate position I is set.
The intermediate position I is approached from the upper
limit position.
36 - en

Factory setting

Alarm signal function on
Drive control unit
Roller shutter/awning operation

Programming