Cleaning - Becker Centronic UnitControl UC520 Notice De Montage Et D'utilisation

Checking the intermediate position II
Press the UP button twice within one second.
The shading solution runs to the intermediate position II.
Deleting the intermediate position II
Press the intermediate position II programming button
5 seconds. The indicator lamp will then flash briefly three times.
The intermediate position II is now deleted.
Information for venetian blind operation
In venetian blind operation, the venetian blind runs in touch
mode to facilitate precise positioning of the slats. If you
press a travel button for longer than 1 second, the venetian
blind runs in maintained operation mode.
If an intermediate position II has been saved, this is done
after approaching intermediate position I. If an intermediate
position I has not been saved, the intermediate position II is
executed after the running time has elapsed.
Only clean the device with a suitable cloth. Do not use aggressive cleaning
agents that may damage the surface.
38 - en

Cleaning

for longer than