Explanation Of Functions - Becker Centronic UnitControl UC520 Notice De Montage Et D'utilisation

3. Fit the power supply unit in the socket.
4. Place the control panel in the frame and insert this into the power supply
unit.

Explanation of functions

Manual/Automatic slide switch
In slide switch position " " only manual drive commands and alarm signals can
be performed (e.g.: UP, STOP, DOWN via button actuation).
In slide switch position " " automatic drive commands are performed
(control signals via group control inputs)
Alarm signal
An alarm signal (e.g. wind) is signalled by an illuminated indicator lamp. A con-
tinuous switching signal at the group or individual control inputs for longer
than 5 seconds is deemed an alarm signal.
The ALARM SIGNAL function can be switched on/off via the coding switch 1.
Group control unit
Several drives controlled simultaneously are referred to as a group.
RESET button
Intermediate position I, intermediate position II and the memory run times can
be deleted by pressing the RESET button (with a ballpoint pen or similar ob-
ject).
Intermediate position I
The intermediate position I is any shading solution position of your choosing,
situated between the upper and lower limit positions. Once programmed, this
position can be travelled to from the upper position.
To do so, press the DOWN button briefly twice in succession.
For venetian blind operation, any tilt (intermediate position II) which has been
set is automatically carried out following the intermediate position I.
Intermediate position II
The intermediate position II is any roller shutter/venetian blind position of your
choosing, situated between the upper and lower limit positions. This function
allows you to open the roller shutter from the lower limit position up until the
ventilation slots are opened. With the venetian blind, the slats tilt, and with the
awning, the fabric is tensioned.
30 - en