Intermediate Position - Becker Centronic UnitControl UC520 Notice De Montage Et D'utilisation

Setting the intermediate position I
Requirement: The shading solution is in the upper limit position.
1. Press the intermediate position I programming button
pressed.
2. Also press the DOWN button until you have reached the desired interme-
diate position I. You can make a correction with the UP button or the
DOWN button.
3. Release the intermediate position I programming button
lamp will then flash briefly three times.
The intermediate position I is now saved.
Checking the intermediate position I
Press the DOWN button twice within one second.
The shading solution runs to the intermediate position I.
Deleting the intermediate position I
Press the intermediate position I programming button
5 seconds. The indicator lamp will then flash briefly three times.
The intermediate position I is now deleted.
Intermediate position II
Application
Roller shutter operation
Awning operation
Venetian blind operation
This function allows you to open the shading solution from
the lower limit position until the desired intermediate posi-
tion II is reached. Both limit positions must be set before the
intermediate position II is set.
Setting the intermediate position II
Requirement: The shading solution is in the lower limit position.
1. Press the intermediate position II programming button
pressed.
2. Also press the UP button until you have reached the desired intermediate
position II. You can make a correction with the UP button or the DOWN
button.
3. Release the intermediate position II programming button
ator lamp will then flash briefly three times.
The intermediate position II is now saved.
for longer than
Function
Ventilation
Fabric tension
Turning
and keep it
. The indicator
and keep it
. The indic-
37 - en