Functions; Factory Setting - Becker Centronic MemoControl MC42 Notice De Montage Et D'utilisation

Functions in manual mode
• UP, STOP, DOWN
• Intermediate position
• Ventilation/reverse position
Functions in automatic mode
• UP, STOP, DOWN
• Intermediate position
• Ventilation/reverse position
• Automatic switching times
Moving to reverse position (venetian blind)
When the venetian blind function is being used, the venetian blind moves in non-
maintained command mode in order to allow the slats to be positioned more
precisely. If you press and hold a control button for longer than 1 second, the
venetian blind will remain locked.
After the programmed intermediate position has been reached, the slats will be
automatically adjusted (provided the reverse position has been programmed).
Moving to intermediate position
You should only move the shutter or venetian blind to the intermediate position
or programme it from the upper end limit.
Press the DOWN button twice in rapid succession. The curtain will move to the
stored intermediate position.
Moving to ventilation position
You should only move the shutter or venetian blind to the ventilation position or
programme it from the lower end limit.
Press the UP button twice in rapid succession. The curtain will move to the
stored ventilation position.
Encoding switch setting:
Lower position -> Roller shutter mode

Functions

Factory setting
de
en
fr
nl
17