Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
TEST mode
The TEST mode is activated by adjusting the threshold value.
This mode will automatically end after approx. 15 minutes. Alternatively, the slid-
ing switch can be used to deactivate the test mode immediately.
In the TEST mode, the times for the sunshade function and wind control are
reduced.
Sun threshold value: Intermediate position (35KLux)
Wind threshold value: Left limit stop (2 m/s) Intermediate position
Programming the remote control
Caution
Before programming the transmitter, please check whether the
threshold control switches are set to the factory setting. When pro-
gramming the transmitter, ensure that you are not located in the opera-
ting area of the sun protection system.
1) Learning the master transmitter
a) Put receiver into learn mode
Note
Please refer to the operating instructions for the receiver.
• Switch off the receiver's power supply and reconnect after 5 seconds.
or
• Activate the "Learn" key or the radio-controlled receiver switch.
The receiver will then be in "Learn" mode for 3 minutes.
b) Learn master transmitter
When the receiver is in "Learn" mode, the learn button is to be pressed until the
receiver indicates that the learn process has been successfully completed.
The learn process is now complete.
16
Factory setting
Publicité
Table des Matières
