Factory Default Settings; Programming - Becker Centronic MemoControl MC42 Notice De Montage Et D'utilisation

Travelling to tilt position (blind)
When using the blind function, the blind moves in touch mode in order to en-
able precise positioning of the slats. If a travel button is pressed for more than
1 second, the blind moves in maintained operation.
After the programmed intermediate position is reached, the slats are automat-
ically tilted (provided the tilt position has been programmed).
Travelling to intermediate position
Only travel the shading solution to the intermediate position or programme it
from the upper limit position.
Press the DOWN button briefly twice in succession. The shading solution
moves to the saved intermediate position.
Travelling to ventilation position
Only travel the shading solution to the ventilation position or programme it
from the lower limit position.
Press the UP button briefly twice in succession. The shading solution moves
to the saved ventilation position.
Setting the coding switch:
Lower position -> roller shutter mode
Programming the daily run times
To program the desired UP run time, press the UP button for at least 6
seconds. The indicator lamp flashes briefly three times. This drive command
will now be repeated every 24 hours.
To program the desired DOWN run time, press the DOWN button for at least 6
seconds. The indicator lamp flashes briefly three times. This drive command
will now be repeated every 24 hours.
Overwriting the run times is possible at any time. Repeat the
programming phase to set the new desired daily run time.

Factory default settings

Programming

19 - en