Mettler Toledo IND246 Guide D'installation page 25

paper from the adhesive, and press one foot onto each corner of the bottom of the
enclosure, as shown in Figure 2-3.
Bracket Mounting the AC version
Two mounting brackets and four M5 screws are included with the IND246. These
can be used to mount the terminal to a vertical surface. To mount the enclosure
using these brackets, follow these steps:
1. Open the enclosure as detailed in the Opening the Enclosure section. For steps
3 to 8, refer to Figure 2-4:
2. First, the orientation of the front panel must be reversed. This involves
detaching the panel and rotating the housing, and exchanging the openings
used by the power and load cell cables:
Ferrite wire-tied
to anchor
Incoming power cord
Ground wire connected
to ground stud
Figure 2-4: Preparing to Detach Front Panel
IND246 Terminal Installation Manual
Figure 2-3: Rubber Feet
Opening used by
load cell cable
Attachment studs
Ground straps
Power connector
2-3