Opening The Enclosure - Mettler Toledo IND246 Guide D'installation

Chapter 2
Installation
This Chapter covers
•

Opening the Enclosure

• Environmental Protection
•
Mounting the Terminal
•
Installing Cables and
Connectors
•
PCB Switch Settings
• PCB Jumper Positions
•
SD Card Installation
• Capacity Label Instructions
•
Closing the Enclosure
• Sealing the Enclosure
Opening the Enclosure
The front panel of the harsh enclosure IND246 terminal is locked in place by six
spring clips attached to the body of the enclosure. To access the terminal's PCB to
install options, connect internal wiring and set switches, separate the front panel
from the enclosure as follows:
1. Insert the tip of a flat-blade screwdriver into one of the two slots located on the
bottom of the front panel assembly (see Figure 2-1). While squeezing the front
panel and enclosure together, gently push the screwdriver in toward the
enclosure. A "pop" sound is made when the cover clip is released.
This Chapter provides installation instructions for the IND246 terminal.
Please read these procedures thoroughly before beginning installation.
This section includes details about opening and mounting the
enclosure and explains how to install any cables to the enclosure.
Instructions for labeling, closing and sealing the enclosure are also
provided.
Figure 2-1: Opening the Harsh Enclosure
2-1