Environmental Protection; Mounting The Terminal - Mettler Toledo IND246 Guide D'installation

IND246 Terminal Installation Manual
2. Repeat Step 1 for the other slot.
3. After releasing the two clips securing the bottom of the front panel, move the
panel to each side to disengage the side clips, then lift the bottom of the front
panel firmly up and out (Figure 2-2, 1) until it completely clears the top edge
of the bottom enclosure.
4. Squeeze the top of the front panel to the enclosure along the top edge slightly
and push upward (Figure 2-2, 2) to unsnap the top two clips, then lift the
cover to clear the two top clips. The cover will swing down, hinged by two wire
cables at the bottom.

Environmental Protection

The IND246 terminal is designed for heavy washdown areas. It has been tested
and found to meet IP66 standards. An IP66 rating is similar to a Type 4 and a
Type 6 rating.

Mounting the Terminal

The harsh enclosure can be placed on a desktop or mounted to a more vertical
surface using the brackets included with the terminal. Mount the terminal where
viewing is optimal and the terminal keypad is easily accessible. Observe location
and environment considerations as described in Chapter 1, Introduction.
Desktop Mounting
When the IND246 terminal will be placed on a flat surface, the four self-adhesive
rubber (included with the terminal) should be attached to the bottom of the
enclosure to prevent sliding. Locate the four rubber feet, remove the protective
2-2
2
1
Figure 2-2: Removing the Cover
THE IND246 IS NOT DESIGNED FOR USE IN AREAS CLASSIFIED AS
HAZARDOUS BECAUSE OF COMBUSTIBLE OR EXPLOSIVE ATMOSPHERES. DO
NOT INSTALL AN IND246 INTO AN EXPLOSIVE ENVIRONMENT.
WARNING!