Unpacking Instructions; Handling The Machine - John Bean QUADRIGA 1000 Manuel D'utilisation

c
122
ii-2
b
a
b
ii-3
1
e
f
ii-4
Installation Instructions

Unpacking instructions

Uncrate the machine paying particular attention when
cutting the plastic straps or during any other operation
which may be hazardous.
After removing the external cover check for any visible
damage to the machine and its components.In case of
doubt call qualifi ed personnel for assistance.
The packing materials (plastic bags, polystyrene, nails,
screws, wood etc.) must be properly disposed of.
Place the above mentioned materials into a trash
container and dispose per local regulations.
WARNING: ALWAYS WEAR GLOVES WHEN
UNCRATING THE MACHINE TO PREVENT
SCRATCHES OR ABRASIONS DUE TO CONTACT
WITH PACKING MATERIALS.

Handling the machine

In case the machine is to be moved from one working
place to another, proceed as follows:
Fix the lifting bracket (a, Fig.ii-3) to the area
•
shown here and indicated by the relative plate on the
machine (Fig.ii-2) using the bolts (b, Fig.ii-3) supplied,
as shown.
Screw the rod (3, Fig.ii-3) securely into the seat-
•
ing.
Bring the bead pusher arm "c" to its working
•
position and tie it to the wheel machine upright so it
does not move during transport.
Rise the wheels lifter (
•
Move the Center Post (
towards the column of the machine.
Disconnect the electrical and pneumatic power
•
supplies.
Remove from the machine any accessories or
•
parts that might fall during handing and so cause
danger.
Fasten the belt at the suggested lift point (1, Fig.
•
ii-4).
WARNING:USE LOAD STRAPS AND HOOKS WITH A
LOAD-BEARING CAPACITY OF AT LEAST 1000 KG.
Lift with a suitable hoist or fork-lift truck.
•
WARNING: DO NOT USE METAL CABLES DO
NOT USE STORAGE BELTS
PACKING STRAPS.
Remove the lifting racket (a, Fig.ii-3).
•
Operator's Manual
e
, Fig.ii-4) completely up.
f
, Fig.ii-4) completely
DO NOT USE
QUADRIGA 1000/BB QUADRIGA 1000/BB