Table des Matières
Publicité
10
2
13
14
9
1
R
G
98
11
12
6.0-1
6.0-2
6.0-3
Maintenance
carry out:
• Removal of accumulated grease and dirt with a dry
cloth.
• Restoration, using a suitable amount of grease of
the lithium soap type (WZ10 Oilshot grease), order
code: EAA0394G10A.
on the parts:
Figure 6.0-1
2) Vertical activation bar on tools
Every week
carry out:
•
Wash with cold water and soap or non-aggressive
chemical detergents.
•
Dust only the
bead breaking disks and tool guards
with talc.
on the parts:
Figure 6.0-1
9) Plastic guards for lifter parts
10) Plastic guards on mount/demount tool
11) Bead breaker disks
12) Plastic guard on wheel holder base.
Perform the following:
•
Clean with a dry cloth
•
Restore a thin fi lm of protective oil
on the following parts:
-) Wheel clamping hub nut
13) Vertical slide cylinder rods on tools
14) Front lifter pneumatic cylinder rods
Figure 6.0-2
•
Use compressed air or a hard brush to remove any
residue built-up on the microswitch (1, Fig. 6.0-2),
located on the base of the lower bead breaker.
Note:
Do not press the micro excessively in order
to avoid compromising the calibration.
Figure 6.0-3
•
Check that the lubrication unit is working properly.
One oil drop falling into the transparent cone G every
4-5 complete strokes of the bead breaker indicates
that the correct amount of oil is being dispersed in
the system. If necessary,
•
Adjust the unit using the screw 'R' to correct the oil
fl ow so it is as indicated above.
Every day
Perform the following:
•
Clean with a dry cloth
the following parts:
Figure 6.0-1
10) Mount/demount tool plastic guards
11) Bead breaker disks
•
Clean with a dry cloth and compressed air.
Operator's Manual
QUADRIGA 1000/BB
Publicité
Table des Matières
