John Bean QUADRIGA 1000 Manuel D'utilisation page 108

"Hint 01"
can't load
" "
"Hint 02"
can't unload
" "
"Hint 10"
"tire present"
"Hint 11"
"tire absent"
"Hint 12"
"rim absent"
"Hint 14"
"switch pressed"
"Hint 15"
"Can't find rim"
108
"Hint"
"Hint 01"
"kein Beladen!"
"Hint 02"
"kein Entladen!"
"Hint 10"
"Reifen montiert"
"Hint 11"
"Reifen fehlt"
"Hint 12"
"Felge fehlt"
"Hint 14"
"Schalter aktiv"
"Hint 15"
"Felge unsichtbar"
Trouble shooting
Below is a list of the messages that may be displayed
on the User Interface, divided into:
HINTS and ERRORS
Note: The viewer can show information in English
or German. Contact the assistance service
to change the language.
A list of the HINTS shown on the Display:
"Hint 01"
"Wheel cannot be loaded"
The wheel load procedure cannot be performed because the
Wheel Sensor Arm has not been activated.
Possible causes:
1) Insuffi cient wheel diameter.
2) Front lifter empty.
3) Sensor damaged; (Call the Technical Assistance Service)
"Hint 02"
"Wheel cannot be unloaded"
The wheel unload procedure cannot be performed because
the Wheel Sensor Arm is activated.
Possible causes:
1) There is another wheel on the front lifter.
2) The Sensor has been activated following a fault; (Call the
Technical Assistance Service)
"Hint 10"
This hint is displayed during the laser scan step
of the Automatic Mounting procedure.
Possible causes:
1) The wheel diameter set is less than the correct diameter.
2) The laser sensor has detected something that is nearer
than the rim edge (e.g.: the tire).
"Hint 11"
This hint is displayed during the Automatic
Demounting procedure if the side of the tire has not been
registered by the bead breaking sensors.
Possible causes:
1) The rim diameter set is incorrect.
2) A rim without a tire has been loaded.
3) The bead breaking sensors are not operating correctly;
(Call the Technical Assistance Service)
"Hint 12"
This hint is displayed during the laser scan step
of the Automatic Mounting procedure.
Possible causes:
1) The rim diameter set is bigger than the actual diameter.
2) There is no rim on the machine.
"Hint 14"
"A Switch is Engaged"
This error may be displayed when the machine starts up, If
a command or switch is activated.
"Hint 15"
"Rim border not reached from laser"
During BeadBreak and laser sensor search, this hint is shown
if the border is not found in the expected position or the tire
hides it to the sensor.
Operator's Manual QUADRIGA 1000/BB