John Bean QUADRIGA 1000 Manuel D'utilisation page 38

5
6
2
38
4.1-1
4.1-2
3
4.1-3
Layout
or,
5, Fig.4.1-1 - Automatic Mounting ;
(Full Tire Mount); if just a rim with no tire is clamped
onto the Wheelholder Flange.
At this point to start the actual program the operator
needs to
• keep the lever (2, Fig.4.1-2) on the Control Unit
activated until all the individual work phases are
enabled and performed in the correct order for the
entire course of the program.
This guarantees that the operator is in constant control
of all the tire changer movements and can interrupt
it rapidly in the event of problems or malfunctioning.
The operator can choose, at any time, to release the
lever and interrupt the cycle. If the main on/off switch
is left on and the operator does not exit the Automatic
modes currently in progress, work can be continued
from wherever the operator chooses.
Activating the lever in the
the movements in reverse until the tools are in the
idle position.
Note: The defi nition "Idle Position" refers to the
operating parts of the machine (bead
breaking tools and disks) and indicates
that they have moved right away from the
tire and are not currently in operation.
4.2.1 Automatic Demounting Program
Having completed the preliminary operations and
having pressed the Automatic Demounting key
(6, Fig.4.1-1), the machine is ready to run the
Subprograms in the tire demounting program.
Within the Automatic Demounting Program the
following Subprograms are run in this order:
- Bead breaking
- Removing the upper bead
- Removing the lower bead
Note: Every time the machine interrupts an
automated phase, the operator must
release the lever (2, Fig.4.1-2) and
perform the required operation (described
in the Operations chapter).
Operator's Manual
opposite direction runs all
QUADRIGA 1000/BB