Pairing The Transmitter And Receiver; Setting The Volume - Marmitek Audio Anywhere 725 Guide Utilisateur

2. Connect the adapter to the micro USB port and plug the
adapter into the wall socket. The red LED flashes slowly
when the battery is charging.
3. Press the on/off button. The Audio Anywhere 725 receiver
will now switch on and the blue LED will flash slowly. (The
red LED flashes occasionally when the battery is still
charging.)
4.4

Pairing the transmitter and receiver

Upon first use, the receiver must be paired with the transmitter.
Make sure the transmitter and receiver are switched off.
1. Press and hold the transmitter's on/off button for 2 seconds.
The red/blue LED will now start to flash. The transmitter is
now in pairing mode for 20 seconds.
2. Shortly press the receiver's on/off button. The red/blue LED
will now start to flash, after which the blue LEDs on the
transmitter and receiver will light up continuously to indicate
successful pairing. (If the LEDs continue to flash rapidly, the
transmitter was probably in pairing mode for more than 20
seconds, cancelling the pairing. You will then need to put the
transmitter into pairing mode again and re-try pairing the
transmitter and receiver.)
4.5

Setting the volume

On the transmitter, you can adjust the volume to all receivers
using the + and - buttons.
On the receiver, you can adjust the volume per receiver.
10 © MARMITEK