Switching On; Pairing - Marmitek SURROUND ANYWHERE 221 Guide Utilisateur

Surround Anywhere 221
audio receiver (RX)
Please ensure that the ON/OFF switch on the audio receiver is in the off
position.
Connect the 18V power adapter (D) to the audio receiver and a power outlet.
5.3

Switching on

Once all the connections are done, you can start using the Surround
Anywhere 221. First, turn on your surround set and play a DVD or Blu-ray
disc with 5.1 channel sound at low volume. Please ensure that the volume
button on the Surround Anywhere receiver (RX) is approximately in the
middle position. Always turn on the transmitter first. The blue LED will now
start to flash slowly. Turn on the receiver. The LEDs on both the transmitter
and the receiver will now be blue continuously, indicating that they are paired.
Now, adjust the volume on the Surround Anywhere receiver (RX) as required.
5.4

Pairing

The Audio Anywhere 221 transmitter and
receiver are already paired. If the LEDs on
the transmitter and receiver continue to
blink slowly, you can pair the set again.
At the back of the receiver, press the
pairing button for a few seconds.
The LED will now flash quickly.
Then, also press the pairing button at the back
of the transmitter for a few seconds. The
transmitter will now instantly connect to the
receiver, and the LEDs will light up continuously.
Surround Anywhere 221™ 11