Using The Digital Output Jacks; Connecting Monitor Speakers That Have Digital Input Jacks; Connecting An Md Recorder - Roland Edirol M-100FX Mode D'emploi

Basic operation

Using the digital output jacks

The M-100FX provides two types of digital output jack; OPTICAL and
COAXIAL. These two jacks output the same signal (sound). Use the jack that
is appropriate for the cable and device you are connecting.
fig.digital
Monitor speakers
■ Connecting monitor speakers that have digital
input jacks
If your monitor speaker system has a digital input jack, you can connect it
to the digital output jack located on the rear panel of the M-100FX. Since the
signal is sent in digital form to your monitor speakers, the signal will
experience less degradation and noise.
Use the master volume fader to adjust the volume. This allows you to
adjust the volume even if your monitor speakers cannot adjust the volume
of a digital input signal.

■ Connecting an MD recorder

If you want to record the sound mixed by the M-100FX onto your MD or
DAT recorder, connect your MD recorder to the M-100FX's digital output
jack.
Use the master volume fader to adjust the volume.
30
Use the jack that is
appropriate for your
equipment
Optical digital cable Coaxial cable
MD recorder
The sampling frequency
is 44.1 kHz.
Before you make
connections, turn down the
monitor level knob and
headphone volume knob
to the minimum position in
order to protect the
circuitry. If monitor
speakers are connected,
turn down the speaker
volume as well.