Windows Me/98 Users - Roland Edirol M-100FX Mode D'emploi

16.
The Insert Disk dialog box will appear. Click [OK].
17.
The Files Needed dialog box will appear. Input the
following into the "Copy files from" field, and click
[OK].
D:\DRIVER\USB_XP2K
* If the "Driver Signing Options" setting was not set to
"Ignore" in step 4, a dialog box will inform you that the digital
signature was not found. Click [Yes] to continue installation.
18.
The Found New Hardware Wizard will appear. Verify
that "EDIROL M-100FX" is displayed, and click [Finish].
19.
When driver installation has been completed, the
System Settings Change dialog box will appear. Click
[Yes].
Windows will restart automatically.
Next, you will need to make the
driver settings.
(→ Driver settings (p. 166))

■ Windows Me/98 users

1.
With the M-100FX disconnected, start up Windows.
Disconnect all USB cables except for a USB keyboard and
USB mouse (if used).
2.
Exit all currently running software (applications).
Also close any open windows. If you are using virus
checking or similar software, be sure to exit it as well.
3.
Insert the CD-ROM into the CD-ROM drive of your
computer.
4.
Click the Windows Start button. From the menu that
appears, select "Run...".
5.
In the "Run..." dialog box, input the following into the
"Open" field, and click [OK].
D:\DRIVER\USB_ME98\SETUPINF.EXE
* The drive name "D:" may be different for your system. Specify
the drive name of your CD-ROM drive.
6.
The SetupInf dialog box will appear.
You are now ready to install the driver.
* If a message recommends that you restart Windows, restart
Windows as directed, and then proceed to the next step.
7.
Place the M-100FX's ADVANCE (mode select) switch in
the ON position.
8.
With the power switch turned OFF, connect the AC
adaptor to the M-100FX.
9.
Connect the AC adaptor to an electrical outlet.
10.
Use the USB cable to connect the M-100FX to your
computer.
11.
Set the M-100FX's power switch to the ON position.
12.
The driver will be installed automatically.
13.
In the SetupInf dialog box, click [OK].
* If a message recommends that you restart Windows, restart
Windows as directed.
Next, you will need to make the
driver settings.
(→ Driver settings (p. 166))
Using Advance mode
165