Wearing Parts; Safety Regulations; Correct Use / Areas Of Application - Solo 416 Li Notice Originale

1 Wearing parts / 2 Warranty / 3 Safety regulations
1 Warranty
We warrant problem free quality and will cover the
cost of replacing parts which are found to be faulty
in material or show manufacturing defects within
the prescribed guarantee period after the date of
purchase.
Please note that specific guarantee conditions may
differ from country to country.
When in doubt, please ask the vendor of the
goods. The vendor of the product is responsible for
guarantee applications.
We hope you will understand that we cannot be
liable for damage resulting from these causes:
 Non-compliance with operating instructions.
 Neglecting required maintenance and repair
jobs.
 Wear from normal use (particularly: gasket
seals, membranes, collars, spray nozzles and
filters).
 Using non-approved tools.
 Use of force, improper treatment, misuse and
accidents.
 Attempted adjustments and repairs by
non-qualified persons.
 Unauthorized modification or changes made to
the device.
 Use of unsuitable spare parts or non-genuine
parts if such parts are the cause of the damage.
 Use of non-approved media in the spraying
agent tank.
 Damage caused by using the product in the hire
or rental industry.
Normal cleaning, adjustments or maintenance jobs
cannot be claimed as part of the guarantee.
All guarantee work must be carried out by one of
our authorised service centres.
For Australia only: Supplementary warranty notes
specifically for Australia
To make a claim, contact Clayton Engineering, 26
French Ave, Brendale, Q, 4500 on phone 1300 798
022 or email sales@claytonengineering.com.au. You
will be asked to provide proof of purchase and then
will be instructed on the procedure for repairing or
replacement of the product under warranty. All costs
incurred for repair or replace, and additional claims
can be discussed at this stage.
This warranty is provided in addition to other rights
and remedies you have under law: Our goods come
with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a
replacement or refund for a major failure and for
compensation for any other reasonably foreseeable
loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of
acceptable quality and the failure does not amount to
a major failure.
ENGLISH 4

2 Wearing parts

Various parts are subject to application-specific
wear or to normal wear and must be replaced in
good time if necessary.
The following parts are subject to normal wear and
are not covered by the manufacturers guarantee:
 All rubber parts that come into contact with the
spraying agent
 Spray nozzle
 Filters
 Seals
 Rechargeable battery
 Fuse

3 Safety regulations

3.1 Correct use / areas of application

 This pressure sprayer must only be used for the
purpose of applying approved liquid plant
protection agents, pesticides, insecticides, weed
killer (herbicides) and liquid fertilizers available
from authorised specialist dealers as well as for
the purpose of applying clean water.
 Observe all instructions provided by the spraying
agent manufacturer.
 We recommend using only spraying agents that
have been approved for use as spraying agent
for the above mentioned areas of application by
the relevant authorities in your country.

The pressure sprayer must only be used for
applications in agriculture, tree nurseries,
forestry, fruit and vegetable growing, vineyards,
home and garden and greenhouse cultivation
with adequate ventilation.
 The pressure sprayer must not be used for any
other purposes, e.g., for the spraying of liquid
paint or applying any other media than the
above mentioned liquids!
Particularly, aggressive, acid- or solvent-
containing liquids, disinfectants or impregnating
agents must not be sprayed with this device!
 Never use fluids with a temperature in excess of
40 °C [104 °F].
 To enable the operator in connection with the
spraying agent manufacturer to check the
material resistance to certain chemicals, we will
provide details of the type of materials used for
the pressure sprayer.