Preface
Dear Customer,
Congratulations for choosing this SOLO
quality product.
The cultivator attachment 69 00 150 is
delivered with a pre-assembled lower shaft tube.
It is solely designed for installation on SOLO
brushcutters 129LTS and 129BTS, both with
sectional shaft. A simple, quick tool change is
made possible as the lower shaft tube can be
replaced with the tool head attached.
These instructions will only show the
additional aspects for use of the base tool and
the attached cultivator as opposed to the
instructions detailing the use of the brushcutter.
Basically, all the instructions for the brushcutter
are to be taken into account, in particular the
safety instructions.
We wish you many years of problem free,
successful work.
If, after having read both these instructions
and those of the brushcutter you still have
questions, then please contact your local SOLO
dealer or our service department directly.
CE Declaration of conformity
SOLO Kleinmotoren GmbH, Stuttgarter Str. 41,
D-71069 Sindelfingen,
hereby declares that the following machine, to which
this declaration refers, meets the requirements of the
EC Directives 98/37/EC, 2000/14/EC and 89/336/EEC (as
amended by 92/31/EEC)
Product designation:
Model/type:
meets the requirements of the Machinery Directive.
This declaration of conformity loses its validity, if the
equipment is converted or modified without the
manufacturer's consent.
Sindelfingen,
1
January 2005
st
SOLO Kleinmotoren GmbH
ENGLISH
2
Cultivator attachment
69 00 150
Wolfgang Emmerich
Executive Director
Symbols
The following symbols are used in these
instructions and on the tool which are additional
to the symbols used on the brushcutter:
Always handle this tool with particular
care
Read these instructions and the
brushcutter instructions
Keep feet away from the operational
area of the cultivator
Before any cleaning or maintenance
work switch off engine and remove
spark plug cap
Never touch rotating blades. Always
switch off the engine and remove
spark plug cap, before any contact
with the blades
1. Parts subject to wear and tear
Various parts are subject to application-specific
or normal wear and must be replaced in good
time, when required. The following parts are
subject to normal wear and are not covered by
the manufacturer's guarantee:
Tilling blades and their fasteners
Protection
Lubricants