Using The Pressure Sprayer; Spraying - Solo 416 Li Notice Originale

CAUTION:
Never fill different spraying agents into the
spraying agent tank without first thoroughly
cleaning the tank and all parts that come into
contact with the spraying agent and flushing the
system with plenty of clean water.
Recommendation: Use the special SOLO cleaner
for plant protection sprayers (dosing bottle of
500 ml [approx. 16.9 oz], part no.: 49 00 600).
Never use aggressive, acid- or solvent-containing
cleaning agents (gasoline for example).

8 Using the pressure sprayer

Ensure that you follow all of the safety
instructions when using the pressure sprayer.
Every time you use the pressure sprayer, first
check it all over to ensure it is safe to use
according to section 10.

8.1 Spraying

 When applying spraying agent, ensure by using
appropriate measures and procedures that the
unintended release of agent to other areas is
minimized and the drift to the surrounding areas
is prevented.
 Always proceed with the greatest care when
spraying.
 Never use the device under windy conditions or
if it is raining, as this would risk widespread
drifting of the spraying agent.
 Check the wind direction before starting work
and select the spraying direction downwind of
the user.
 It is best to perform spraying work in the morning
or evening, as it tends to be less windy then.
7 Mixing spraying agents and filling the spraying agent tank / 8 Using the pressure sprayer
Identification of the tank
contents:
Attach the relevant
sticker to the spraying
agent tank to indicate the
contents of the tank (i.e.,
herbicide, fungicide or
insecticide).
The designation of the
spraying agent used has
to be attached to the
device and has to be
updated every time when
the spraying agent is
changed.
 Ensure that you only wet what is in fact intended
to be covered with spraying agents.
 Never spray the agent towards persons,
animals, open windows or doors, cars or
anything else that could be damaged by the
spraying agent.
 Use the spray nozzle suitable for your
application. Applicable nozzles: See section 13
 When spraying, ensure that the spraying agent
is applied evenly and homogeneously to the
treated area.
 Carry the properly adjusted and prepared device
on your back.
 Leave the shut-off valve closed when you switch
on the pump (i.e. do not pull the lever).
 Select the required operating pressure at the
pump toggle switch according to the required
range and delivery rate.
In setting II the pump automatically switches off
when the operating pressure is reached at the
shut-off valve. If the pressure drops while
spraying, the pump will automatically switch
back on again. This ensures that the full capacity
of the rechargeable battery is used in the best
possible way.
In setting I, the switch-off pressure may not
always be attained even if the shut-off valve is
closed, and the pump will then run continuously
as a result. In this case we recommend
switching the pump off manually using the toggle
switch during breaks in spraying.
Always completely switch off the pump using the
toggle switch before extended breaks or at the
end of spraying.
 Never allow the pump to run with an empty
spraying agent tank. Running the pump dry will
result in pump damage.
Spraying:
Hold the spray tube at the shut-off valve in your
hand.
Start the spraying process by pressing the shut-off
valve (8).
Releasing the shut-off valve stops the spray
process.
ENGLISH 13