Taking The Sprayer Out Of Service And Putting It Into Storage - Solo 416 Li Notice Originale

9 Maintenance, cleaning and storage
Draining the spraying agent tank:
 Place the pressure sprayer level on a horizontal
surface.
 Rotate the two locking buttons (17)
approximately 100° anti-clockwise to release the
protective casing. Open the protective casing.
 Hold the end of the discharge hose (19) into a
suitable container.
 Open the drain valve (18) (the lever should be
set parallel to the hose).
 After draining: Close the drain valve (the lever
should be set at right angles to the hose) and
reattach the discharge hose to the rear panel.
 Close the protective casing and twist the locking
buttons back in a clockwise direction until they
are horizontal.
Cleaning the spraying agent tank:
Drain the spraying agent tank and all other
spraying agent carrying parts daily after use and
particularly at the end of the spraying season and
thoroughly flush them with clean water.
Any unused spraying agent that is left over in the
device could cause corrosion and hence damage
the device. Special attention must be paid to
wearing parts like spray nozzles, filters and seals.
Please read and observe the cleaning instructions
supplied with the spraying agent.
Recommendation: Use the special SOLO cleaner
for plant protection sprayers (dosing bottle of
500 ml [approx. 16.9 oz], part no.: 49 00 600).
Never use aggressive, acid- or solvent-containing
cleaning agents (gasoline for example).
After cleaning, leave the spraying agent tank open
to dry.
ENGLISH 16
Cleaning the filling strainer, the spray nozzle and
the ball valve filter:
 Rinse the nozzle attachment with clean water.
 Disassemble the nozzle attachment (11).
 Clean the filling strainer, the O-rings, the ball
valve filter and the spray nozzle with clean water
and a soft brush. Never use your mouth to blow
through the spray nozzle! Never use hard
objects to clean the nozzles!
 Reassemble the components of the nozzle
attachment.
9.9 Taking the sprayer out of service and
putting it into storage
Prepare the device for storage according to
section 9.8.
Store the device protected from sunlight in a
secure, dry and frost-free location at a maximum
ambient temperature of 35 °C [95 °F].
There must not be any open fires or similar
nearby.
Even when the device is not in use, regularly
recharge the battery (and the spare battery if you
have one) once a month with the supplied charger.
Ensure that the unit cannot be used by
unauthorised persons, in particular children.