Taking The Sprayer Out Of Service And Putting It Into Storage; Wearing Parts; Warranty - Solo 425 Comfort Instructions D'emploi

6 Maintenance, cleaning and storage / 7 Wearing part / 8 Warranty
Cleaning the spray nozzle, the filter element and
the filling strainer:
x To depressurise the device, hold the spray tube
in the spraying agent tank or in a suitable
container for the spraying agent and operate the
shut-off valve until no more fluid is sprayed.
x Rinse the nozzle attachment with clean water.
x Disassemble the nozzle attachment .
x Clean the O-rings, the filter element, the spray
nozzle and the filling strainer with clean water
and a soft brush.
Never use your mouth to blow through the spray
nozzle! Never use hard objects to clean the
nozzles!
x Reassemble the components of the nozzle
attachment (Fig. 22).
6.8 Taking the sprayer out of service and
putting it into storage
Prepare the device for storage according to
section 6.7.
Store the device protected from sunlight in a
secure, dry and frost-free location under a
maximum ambient temperature of 35 °C [95 °F].
There must not be any open fires or similar
nearby.
Ensure that the unit cannot be used by
unauthorised persons, in particular children.

7 Wearing parts

Various parts are subject to application-specific
wear or to normal wear and must be replaced in
good time if necessary.
The following parts are subject to normal wear and
are not covered by the manufacturers guarantee:
x All rubber parts that come into contact with the
spraying agent
x Spray nozzle
x Filters
x Seals
ENGLISH 12
We warrant problem free quality and will cover the
cost of replacing parts which are found to be faulty in
material or show manufacturing defects within the
prescribed guarantee period after the date of
purchase.
Please note that specific guarantee conditions may
differ from country to country. When in doubt, please
ask the vendor of the goods. The vendor of the
product is responsible for guarantee applications.
We hope you will understand that we cannot be liable
for damage resulting from these causes:
x Non-compliance with operating instructions.
x Neglecting required maintenance and repair jobs.
x Wear from normal use (particularly: gasket seals,
membranes, collars, spray nozzles and filters).
Fig. 27
x Using non-approved tools.
x Use of force, improper treatment, misuse and
accidents.
x Attempted adjustments and repairs by non-
qualified persons.
x Unauthorized modification or changes made to the
device.
x Use of unsuitable spare parts or non-original parts
if such parts are the cause of the damage.
x Use of non-approved media in the spraying agent
tank.
x Damage caused by using the product in the hire or
rental industry.
Normal cleaning, adjustments or maintenance jobs
cannot be claimed as part of the guarantee.
All guarantee work must be carried out by one of our
authorised service centres.
For Australia only: Supplementary warranty notes
specifically for Australia
To make a claim, contact Clayton Engineering, 26
French Ave, Brendale, Q, 4500 on phone 1300 798
022 or email sales@claytonengineering.com.au. You
will be asked to provide proof of purchase and then
will be instructed on the procedure for repairing or
replacement of the product under warranty. All costs
incurred for repair or replace, and additional claims
can be discussed at this stage.
This warranty is provided in addition to other rights
and remedies you have under law: Our goods come
with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a
replacement or refund for a major failure and for
compensation for any other reasonably foreseeable
loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of
acceptable quality and the failure does not amount to
a major failure.

8 Warranty