Adapter With Clamping Rollers - Heidolph UNIMAX 1010 Mode D'emploi

IEI
PROMAX 1020 (preferred), UNIMAX 1010, DUOMAX 1030 and POLYMAX 1040
models.
knurled knobs
with pressure pad
adapter for 50/100 ml
separating funnels
(P/N: 549-78000-00)
The adapter comes as an assembly. It is put on the shaker plate rubber cushion.
Crimped edge of rubber plate is seated over adapter. Adapter is secured with 4 ea,
knurled bolts located in the corners.
Load separatory funnels in place. To this end unlock pressure pad by pulling knurled
knob. Introduce other end of separatory funnel in rubber grommet and allow
pressure pad to travel forward slowly until funnel is locked in place. With this sort of
clamping, funnel's ground plug is held in place firmly.

3.3. Adapter with clamping rollers

The adapter with clamping rollers goes on the shaker plate as described below:
Install 4 ea. bolts (1) in corners and pull tight with box-end spanner (2) from your
hardware bag. Secure rod (3) and clamping roller (4) with wingbolts (5). Extra
clamping rollers are available under P/N 549-71000-00.
knurled bolt
20