Operation And Controls; Duomax 1030 / Polymax 1040 - Heidolph UNIMAX 1010 Mode D'emploi

Before connecting power cord with mains outlet, make sure that:
your item is wired for your local voltage and frequency (data plate on item).
-
master switch is set to "0" and all controls are in "min." position (turn CCW
-
completely); this way you avoid spilling fluids by a too intense shaking action.
Carefully close your vessels and select appropiate shaking intensity (if vessels
remain open) to avoid splashes and spillage.
We recommend to start with low shaking speed and gradually increase frequency to
avoid accidential shaking at high speed.
In general, one single vessel should be arranged in the middle of the shaker plate,
whereas more flasks should be distributed equally over the plate.
At high loads (load-bearing capacity of shaker plate) and high frequency of shaking,
always refer to the load graph applicable for your item (refer to "Specifications"
section).
When handling hazardous fluids, make reference to applicable safety information.
1.
DUOMAX 1030 / POLYMAX 1040 (with mechanical timer)
The control panel features the following controls (from right to left):
A 2-pole master switch (toggle-type, lighted green)
B continuous / timer control selector
C speed selector knob
D timer setting knob
1. Turn item ON with master switch (A).
2. Select shaker frequency with speed selector (C).
3. Select continuous / timer controlled operation with selector (B) (symbol ) or timer
control (timer). In the timer mode, shaking action can be selected between 0 and 120
minutes; time elapsed, item will stop shaking, and a buzzer sounds. The timer will
continue running even in case of power supply failure.
When using shakers inside conditioning cabinets, make reference to
ambient conditions as stipulated in the "Specifications" Section.

OPERATION AND CONTROLS

21
D C B A
IEI