Communication Ports; Rs232 And Usb Connectors; Communication Slots - Gtec SATURN Série Manuel D'installation

C
OMMUNICATION
The UPS is supplied with the following communication ports (see "Views of the UPS):
 Serial port available with RS232 connector and USB connector.
NOTE: the use of one connector automatically excludes the other.
 Port AS400
 Expansion slots for additional COMMUNICATION SLOT interface boards
On the front, covered by the terminal-cover, there is another expansion slot for the power relay board (4 programmable
contacts, 250Vac, 3A)
RS232 USB C
AND
RS232 CONNECTOR
PIN # NAME TYPE
1 IN
2 TX OUT
3 RX IN
4
5 GND POWER
6 OUT
7
8 +15V POWER
9 WKATX OUT
C S
OMMUNICATION
The UPS is equipped with two expansion slots for accessory
communication boards
communicate using the main communication standards.
Some examples:
 Second RS232 port
 Serial duplicator
 Ethernet agent with TCP/IP, HTTP and SNMP protocol
RS232 + RS485 port with JBUS / MODBUS protocol

For further information on the accessories available, visit the web
site.
P
ORTS
ONNECTORS
SIGNAL
Serial line TX
Serial line RX
Isolated power supply
15V±5% 80mA max
ATX power supply wake-up
LOTS
that enable the equipment to
- 98 -
USB CONNECTOR
4 3
1 2
PIN # SIGNAL
1 VBUS
2 D-
3 D+
4 GND