Nput Data; Output Data; Table 9-13: Pyrometer Parameters; Table 9-14: Input Data - Fluke Thermalert 4.0 Manuel Utilisateur

Thermalert ® 4.0
Manuel utilisateur, Rev. 2.0, oct. 2019
9.3 Input Data
Address without offset
0
4
8
The data must be processed (copied) into especially created tags in a correct format in accordance to column
"Format". For example, to obtain the internal temperature of the device, one should create a REAL tag and an
instruction copying 4 bytes of the device's input data into this tag, beginning with byte 12.

9.4 Output Data

Once the pyrometer has been initialized and is running in the data exchange mode, only the below listed
parameters can be changed, using the device's output data.
Address without offset
0
1
The <Type of parameter> gives the meaning of the following parameters with the same format as described in
section 9.2 Parameters, page 65.
66
1.800.561.8187

Table 9-13: Pyrometer Parameters

Attribute ID Name Data type
0x01 Temperature unit
0x02 Emissivity
0x03 Transmissivity
0x04 Device Offset
0x05 Device Gain
0x06 Average Time
0x07 Peak hold Time
0x08 Valley hold Time
0x09 Laser control

Table 9-14: Input Data

Length Format
4 Byte REAL (Big Endian, Motorola)
4 Byte REAL (Big Endian, Motorola)
4 Byte DWORD

Table 9-15: Output Data

Length Format
1 Byte BYTE
4 Byte REAL / UDINT
www.
Data value
USINT 0x43 ('C') – Celsius
0x46 ('F') - Fahrenheit
REAL 0.1 ... 1.1
REAL 0.1 ... 1.1
REAL -200 ... 200
REAL 0.8 ... 1.2
REAL 0.1 ... 999.0
REAL 0.0 ... 999.0
REAL 0.0 ... 999.0
USINT 0 - off, 1 - on
Value
Target temperature
Internal temperature
Error code
Value
Type of parameter
Parameter
information@itm.com
.com
Access rule
Get/Set
Get/Set
Get/Set
Get/Set
Get/Set
Get/Set
Get/Set
Get/Set
Get/Set