Table des Matières
Publicité
Temperature unit
Emissivity
Transmissivity
Average Time
Peak hold Time
Valley hold Time
Laser control
Gain
Offset
8.3 Messages
Message diagnostics alarm
Message process alarm
Behavior on module fault
8.4 Input Data
Address without offset
0
4
8
8.5 Output Data
The output data may be used to change the initialization of the device (which was set once at start-up) when the
bus is in data exchange mode.
Address without offset
0
1
1.800.561.8187
Table 8-7: Pyrometer Parameters
Parameter
Set the temperature unit
*1000, in thousandths (0.9 → 900)
*1000, in thousandths (1.0 → 1000)
*0.1 s, in tenths (1 s → 10)
*0.1 s, in tenths (1 s → 10)
*0.1 s, in tenths (1 s → 10)
Amplification adjustment for temperature
value
Shift adjustment for temperature value
Parameter
The diagnostics information of pyrometer is not
transferred to the PROFINET IO controller
is transferred to the PROFINET IO controller
The process alarm of pyrometer is not transferred
to the PROFINET IO controller
is transferred to the PROFINET IO controller
Length
4 Byte
4 Byte
4 Byte
Length
1 Byte
4 Byte
www.
Description
Table 8-8: Messages
Description
Table 8-9: Input Data
Format
REAL (Big Endian, Motorola)
REAL (Big Endian, Motorola)
DWORD
Table 8-10: Output Data
Format
BYTE
REAL / UDINT
.com
Setting
Celsius, Fahrenheit
100...1100
100...1100
1 ... 9990
0 ... 9990
0 ... 9990
off/on
0.8000 ~ 1.2000
-200.0 ~ 200.0°C / -360.0 ~ 360.0°F
In current unit (°C/°F)
Setting
message inactive (default)
message active
message inactive (default)
message active
set process data to zero, set process data
to last value
Value
Target temperature
Internal temperature
Error code
Value
Type of parameter
Parameter
information@itm.com
8
PROFINET IO
Messages
63
Publicité
Table des Matières
