Double Sided (Df) Clock - Bodet Profil 960 Manuel D'installation

2.3 Double sided (DF) clock

There are two models of double sided clock:
- Integrated model, with one support combining the two clock faces.
- Model with double-sided support (console), on which 2 single face clocks are mounted.
2.3.1 Integrated double sided clock
Drill mounting holes in the wall, pillar etc. to the given
dimensions then affix the mounting bracket.
- Unscrew the 2 screws (B) on each face by 10 mm.
- Remove the two faces by turning anticlockwise
(for receiver clocks, do not forget to disconnect the
2 movements).
- Fix the double-sided mounting bracket after passing
the cables either via the plate (6), or via the cable hole
on the side of the mounting bracket (7).
- Make the required connections (see § Power supply,
page 7, and § Setup and initial time setting, page 7).
- Switch on power to the clock.
- Offer each clock face to the support, then turn it
clockwise to bring the clock to its final position.
- Tighten the screws (B) to fasten the clocks against
turning.
2.3.2 Console-mounted double sided clock
- Drill mounting holes in the wall, pillar etc. to the given
dimensions then affix the mounting bracket.
- If necessary, make the required connections (see
§ Power supply, page 7, and § Setup and initial time
setting, page 7).
- To do this, pass the cables either via the plate (6), or via
the cable hole on the side of the mounting bracket (7).
- Fix the clock (or clocks) to the console by the 2 threaded
pins (C).
22