Installation; Mechanical Installation; Wall Mounting With Screws; Wall Installation With Locking Disc - Bodet Profil 930 Manuel D'installation Et De Mise En Service

2. Installation

Select a location to install the clock, preferably away from sources of electrical interference, such
as transformers.

2.1 Mechanical installation

2.1.1 Wall mounting with screws

These clocks are simply hung on a screw
1/ Install a 4 mm-diameter screw at the desired height, with the head protruding by 3 mm,
2/ Carry out the wiring according to the type of clock and power supply (see chapter 2.2),
3/ Install the clock in place.

2.1.2 Wall installation with locking disc

Thin wall bracket (ref: 981 003):
1/ Fix this bracket with four 6 mm-diameter screws after passing the wiring inside the disc,
2/ Carry out the wiring according to the type of clock and power supply (see chapter 2.2),
3/ Place the clock on the bracket (12 o'clock must be tilted to the left) and turn it clockwise to bring
the clock into its final position.
2
1
Wall bracket (ref: 981 006):
Place the disc on the back of the clock and turn clockwise to lock the
bracket.
The opening for the cables should be downwards.

2.1.3 Installation on double-sided mounting

1/ Fix the double-sided bracket to the wall or ceiling with two
6 mm-diameter screws,
2/ Carry out the wiring according to the type of clock and power supply
(see chapter 2.2),
3/ Place the clocks on the bracket (12 o'clock should be tilted to the left)
and turn them clockwise to bring them into their final positions.
head:
3
Clic
2
4
Clac
EN
7