Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
VIII - Connecting a double face clock
1) Open up the 2 clocks by removing the 9 screws (R).
2) Pass the connector (HE14) through the grommet (S) on each clock, and connect it to the
male connector (T).
Caution
■
Cables for respectively the master clock and the slave clock are not the same: there is a
specific mark for each of these.
■
The cables for the master is one meter long. This cable can not be extended as it may
cause a problem with the clock operation mode.
3) Close up the clock again.
4) Connect the 230 VAC 50/60 Hz mains supply (cf. Chapter 3) and whatever the type of master
clock, the slave clock wire to the master clock.
20
Publicité
Table des Matières
