Procedure To Connect The Serial And I/O Ports To An External Cable - Agilent Technologies TPS-mini Notice De Mode D'emploi

17 Technical Information
P1 – Vent
Figure 20
Procedure to Connect the Serial and I/O ports to
an External Cable
In the following picture, it has showed the right procedure to
connect a cable to the I/O or to the serial port.
A shieleed cable of 30 m (to be checked with Riccardo the max
length) maximum length has to be utilized for both serial and I/O
port connection.
Take care to have a good contact between the metallic case and the external
NOTE
shield of the wire. Moreover, this operation has to be done at least on the
controller side.
286/318
FRG-700 gauge dimensions
TPS-mini User Manual / 87-901-003-01 (E)