Table des Matières
Publicité
SELECTING RPM
The rpm can be adjusted by rotating the wheel (3). The choice
of speed depends on the characteristics of the abrasive disc
and the material to be worked.
ACCESSORIES DISASSEMBLY
- Lock the spindle by pressing button (14), while at the same
time rotating the pad until it locks position.
- dismount the pad.
Never press the button to lock the pad or pas until the
tool has stopped moving and is perfectly stationary;
the gear box or the push button pin could be broken
and the guarantee would be invalidated.
ALLOWED ACCESSORIES
Polishing foam and foam support pad up to Ø 200 mm max.
NOISE EMISSION VALUES
Detected noise emission values comply with the following
directives:
EN 60745-1
SOUND PRESSURE LEVEL
SOUND POWER LEVEL
UNCERTAINTY
Use ear protection!
VIBRATION EMESSION VALUES
Detected vibration emission values comply with the following
directives:
EN 60745-1
3 AXIS VIBRATION LEVEL
UNCERTAINTY
Displayed emission values are comparative and are to be
employed for a provisional assessment of the operator's risk
exposure during the work period. Appropriate evaluation of
work period must also include tool's idle and stop periods.
These emission values represent the tool's main applications.
If the tool is used for other applications, with other accessories,
or if it does not undergo regular maintenance, emission values
can significantly increase during operations.
Danger! The indicate measurements refer to new power
tools. Daily usa causes the noise and vibration values
to change.
LH16ENS LH18ENS LH22N/LH22EN
dB(A)
79
80
dB(A)
90
91
K
3
3
LH16ENS LH18ENS LH22N/LH22EN
m/s
2.7
2.8
2
K
1
1
MAINTENANCE
All maintenance operations are carried out with the power
supply disconnected.
At the end of each work session, or when required, remove any
dust from the body of the tool using a jet of compressed air,
paying particular attention to the motor ventilation slots.
No other maintenance operations must be undertaken by
the user.
Maintenance and cleaning of the inner parts, like brushes, ball
bearings, gears etc. or others, must be carried out only by an
authorized customer-service workshop.
DISPOSAL (WEEE DIRECTIVE)
At the end of its useful life, the product, pursuant to
European Directive 2002/96/CE (WEEE) + 2003/108/
CE and its implementation in national law, must not be released
into the environment or thrown away as domestic waste, but
must be disposed of at authorised recycling centres (contact
the relevant local authorities for a list of places where the
product may be disposed of according to the law). Disposing
of the product correctly contributes to protecting human health
and safeguarding the environment.
Any illegitimate disposal of the product will be punishable by
law.
CONFORMITY DECLARATION
80
91
We declare on our responsibility that the represented tool is in
3
conformity with the Essential Requirements of Safety of the
following Directives:
2006/42/CE, 2004/108/CE, 2011/65/CE.
The tests have been carried out in accordance with the
European Harmonised Standar
EN 60745-1: 2008, EN 60745-2-3: 2007;
EN 55014-1: 2006 + A1: 2009 + A2: 2011;
EN 55014-2: 1997 + A1: 2001 + A2: 2008;
EN 61000-3-2: 2006 + A1: 2001 + A2: 2009;
EN 61000-3: 2008;
EN 62233: 2008.
2.0
0.5
THE PRESIDENT
G. Valentini
S.p.A
Vermezzo (MI), 21/12/2012
7
Publicité
Table des Matières
