Maintenance & Storage - SKF THAP 030E Mode D'emploi

Masquer les pouces Voir aussi pour THAP 030E:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
7. Maintenance & Storage
Clean the oil suction filter regularly (located opposite the oil inlet connection).
Make sure the oil is clean. Contaminants will cause severe wear, and ultimately
failure, of the pump.
Make sure the air supply is clean and dry. An unfiltered air supply can cause the air
motor to stall or stop.
SKF recommends the use of SKF Mounting Fluid LHMF 300 and SKF Dismounting
Fluid LHDF 900.
The maximum storage time depends on the storage conditions. Recommended
storage conditions are at room temperature with dry surrounding air.
To prepare for storage, add a few drops of air motor oil to the air inlet of the pump.
Connect to the air supply and run the THAP...E slowly for a few strokes. The air used
should have a water vapour pressure dew point that is at least 10 ºC below the
ambient temperature where the pump is to be stored.
14
SKF THAP 030E 150E 300E 400E

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Thap 150eThap 300eThap 400e

Table des Matières