Minimum Recommended Air Quality For The Thap; Oil Cleanliness Requirements And Recommendations For The Thap - SKF THAP 030E Mode D'emploi

Length
Height
Width
Weight
* Can be removed to allow flexible pressure hoses (THAP 030E and THAP 150E) and
high pressure pipes (THAP 300E and THAP 400E) to be fitted to the oil outlet block.
See section 4 for further information.
3.1 Minimum recommended air quality for the THAP...E series
The air quality should as a minimum satisfy the following conditions;
ISO 8573.1:2001 Compressed air -- Part 1: Contaminants and purity classes.
Solid particle: Class 5
Water: Class 4 or better depending on the ambient temperature.
(A water vapour pressure dew point at least 10 ºC below the ambient
temperature is recommended)
Oil: Class 5
3.2 Oil Cleanliness requirements and recommendations
for the THAP...E series
Dirt and metal particles in the oil can cause wear of the piston mating surfaces, leading to
excessive oil leakage and permanent damage to the THAP...E.
The recommended oil cleanliness level should meet or exceed ISO 4406:1999 20/18/15
Using fluids or oils, other than SKF mounting and dismounting fluids, can cause corrosion
and/or damage to the piston mating surfaces. Do not mix fluids or oils of different brands.
Use SKF Mounting Fluid (LHMF 300)
for mounting applications between 0 °C (32 °F) and 35 °C (95 °F) and
for dismounting applications between 0 °C (32 °F) and 10 °C (50 °F).
Use SKF Dismounting Fluid (LHDF 900)
for mounting applications between 35 °C (95 °F) and 45 °C (113 °F) and
for dismounting applications between 10°C (50 °F) and 45 °C (113 °F).
Maximum allowable viscosity of oil at operating temperature is 1 500 mm
6
350 mm (13.9 in)
202 mm (8 in)
171 mm (6.7 in)
11.5 kg (25.3 lb)
405 mm (15,9 in)
13 kg (28.6 lb)
/s.
2
SKF THAP 030E 150E 300E 400E