Guiding The Load - probst STONEMAGNET SM-600-GREENLINE Instructions D'emploi

1. Position the lifting device over the load's center of gravity.
2. Ensure that the entire suction plate area is mounted on the load.
3. Secure load using load safety chain.
•
Lift the device with the sucked load just a little (approx.. 20-30 cm)
•
Throw the safety chain underneath the load (concrete slab) .
Never grip with the hands under load. - Caution: Danger of squeezing hands!!!
•
Suspend and tighten both safety chains. Place the end of the chains into the chain cases.
•
The safety chain must fit tightly to the load (see following figure), in that way that the load is held
in case of a vacuum failure
•
The safety chain must never hang loose under the load, otherwise the load may fall down, in
case of a vacuum failure . Danger of accident!
4. Do not lift the load at an angle.
5. Switch on the energy supply.
→ Light flashes until the vacuum reaches -0.6 bar.
6. Actuate operating element (see figure above according to model).
7. Watch the gauge. Lift the load as soon as the vacuum reaches -0.6 bar (manometer pointer is in the
green zone).

Guiding the load

WARNING
33/43
Risk of injury from uncontrolled movement of the lifting device
►
Use the handle to guide the load.
Maintain a safe distance.
►
Always keep the path and load in eyesight.
Do not walk in front of the load.
Tripping hazard
The load swings in the direction of movement when horizontal travel
stops.
►
Always transport loads as close to the ground as possible and adjust
transport speed to the working conditions.
►
Do not jerk the lifting device as this could cause the device to rotate or
swing.