probst STONEMAGNET SM-600-GREENLINE Instructions D'emploi page 114

4. Operating Instructions
Please read these instructions carefully before using the charger.
[1] This charger has been designed for use on a normal
220V - 240V 50/60Hz mains voltage. It can be used to charge a
variety of 12V lead acid batteries, such as WET, GEL and AGM,
which are widely used for cars, motorcycles and other vehicles.
Battery capacities range from 1,2Ah to 120Ah.
[2] This charger is suitable to charge 12V lead-acid batteries
only.
[3] Clean the battery terminals. Take care to prevent eye or skin-
contact with any corrosion.
[4] Make sure that the area around the battery is well ventilated
during the charging process. When the battery is being charged
some fluid bubbling may occur: this is generated by gases during
the charging cycle.
[5] Whenever possible, disconnect and remove the battery from
the vehicle before charging. Read section 6, Safety Instructions for more
information.
[6] Connect the crocodile clamps to the battery in the following sequence:
First, connect the positive charging lead (red) to the positive terminal.
Second, connect the negative lead (black) to the negative terminal.
7