Attaching / Removing Nozzles - Cleanmaxx 06916 Manuel D'utilisation

Adjusting the Length of the Telescopic Tube
A
Attaching / Removing the Turbo Nozzle
No nozzle adapter (5) is required for the turbo nozzle (9).
• Attaching: Plug the extension tube directly onto the telescopic tube (6), the articula-
tion piece (10) or the extension tube (7). The catch must be heard to engage in place.
The turbo nozzle cannot be attached directly to the suction opening.

Attaching / Removing Nozzles

With the exception of the turbo nozzle (9), all nozzles are attached with the aid of the
nozzle adapter (5).
• Attaching: Plug the nozzle adapter into the suction opening (18). Plug the nozzle
you want onto the nozzle adapter.
• Detaching: Pull the nozzle and nozzle adapter out of the suction opening.
Removing / Inserting the Dust Container
closed
open
25
• Removing: Press the release button on the telescopic tube,
articulation piece or extension tube and at the same time pull
out the corresponding accessory.
• Press the release button (A) on the telescopic tube (6) and
extend the telescopic tube to the length you want.
• Let go of the release button and move the tube a little bit
further until it engages.
• Removing: Press the release button on the turbo nozzle and
pull it off.
• Removing: Untwist the dust container (17) clockwise. This
releases it from the motor unit (13) and it can be removed.
• Inserting: Insert the dust container into the motor unit. Lightly
turn until the locking lugs on the dust container sit correctly
in the recesses on the motor unit. Rotate the dust container
clockwise to fi x it into the motor unit. The release button
on the dust container must be located below the suction
opening (18) after it has been attached.
EN