Attaching / Removing Attachments; Filling The Water Tank - Cleanmaxx 01378 Mode D'emploi

Attaching / Removing Attachments

The adapter (G) is required to secure the smaller attachments (C, D, E, F, I) on the main
unit (A).

Filling the Water Tank

PLEASE NOTE!
■ Do not overfi ll the water tank!
■ Only ever pour tap water and not distilled water or other liquids into the water tank
to prevent any damage to the device!
■ Never pour any cleaning agent or additives into the water tank. This might damage
the device.
01378_de-en-fr-nl_A5_V1.indb 23 01378_de-en-fr-nl_A5_V1.indb 23
23
• Place the carpet glider (K) fl at on the fl oor and insert the clean-
ing foot with fl oor cloth into it.
• Attaching the adapter: Plug the adapter into the attach-
ment mount (6) of the main unit (A). The locking lug
must engage in the associated opening in the attach-
ment mount.
• Removing the adapter: Press the locking lug and at the
same time pull out the adapter.
• Attaching an attachment to the adapter: Plug the at-
tachment as far as it will go onto the adapter nozzle and
rotate it by 90°.
• Removing an attachment from the adapter: Rotate the
attachment on the adapter back by 90° and then pull it
off.
1. Pull the water tank (3) out of the main unit (A). To do
this, press the release button above the water tank and
pull it out.
2. Pull the seal plug out of the water tank.
3. Use the measuring cup (H) that is supplied to pour cold,
clean water into the water tank. It holds up to 370 ml.
4. Plug the seal plug into the feed opening.
5. Insert the water tank into the main unit. It must engage.
EN
10.11.2017 12:20:11 10.11.2017 12:20:11