Charging Up The Battery; Assembly - Cleanmaxx 06916 Manuel D'utilisation

EN

Charging Up the Battery

• It is essential that you charge up the battery (14) fully before you fi rst use the
device in order to achieve the maximum charging capacity. It takes up to 5
hours to charge up the battery.
• The battery status is indicated by a battery symbol with three green bars in
the battery status display (11). When only the last bar is red, the battery's
charge is low and the battery should be recharged.
1. Switch off the device and remove the battery as follows: Press the release button on
the battery and pull the battery out of the device at the same time.
2. Before inserting the battery in the charging station (2), check whether the contacts
are clean and clean them if necessary.
21
20
6. When only the green operating lamp is still lit, the battery is fully charged.
7. First disconnect the mains adapter from the mains power and then disconnect the
barrel connector from the charging station.
8. Press the release button on the battery and pull the battery out of the charging station.
9. Insert the battery into the device. The battery must be heard to engage in place.

Assembly

PLEASE NOTE!
■ Always switch off the device before replacing any accessories.
Attaching / Removing the Telescopic Tube, Articulation Piece and Exten-
sion Tube
For the telescopic tube (6), the articulation piece (10) and the extension tube (7), no noz-
zle adapter (5) is required.
• Attaching: Plug the telescopic tube directly onto the suction opening (18). The catch
must be heard to engage in place. If necessary, the telescopic tube can be extended
in the same way using the articulation piece and / or the extension tube. The se-
quence of articulation piece and extension tube does not matter here.
The articulation piece and the extension tube cannot be attached directly on the
suction opening.
24
3. Insert the battery into the charging station. The two
19
contacts on the battery must press against the two
contacts on the charging station and the battery must
be heard to engage in place.
4. Plug the barrel connector of the mains adapter (1) into
the connecting socket (20) on the charging station.
5. Connect the mains adapter to a properly installed,
easily accessible plug socket. The green operating
lamp (19) and the red charge control lamp (21) will
light up. The battery is being charged.